ซอย สะแกงาม14
ซอย บางกระดิ่16

เครื่องล้างขวด (รหัส: CP-24 )

คะแนน:

CP-24 Bottle Washing Machine Manual

Installation:

1. Voltage is 220V, it needs ground connection before use the machine.

2. Connect the inlet of water, its pressure is 0.2Mpa.

3. Sewage removal must be smooth.

Running:

1. Notice if the motor steering is correct or not before use the machine.

2. Check water outflow from all water nozzle

Specification:

Dimension :90*88*120cm

Bottle holder diameter:8cm

Voltage:220V, Power:0.55kw

Capacity: 2000-3000bottles per hour

Weight:120KG

 

1.Machine feature:

1)Machine can be used for each model and material of bottles, old and new bottle both is ok.

2)Machine can wash surface and internal of the bottle, it is clean.

3)City water or pressure pump flushing is wide adaptability.

4)Simple structure, convenient maintenance, use stainless steel bucket, beautiful and generous and corrosion resistance.

5)Save labor and energy, high production efficiency, suitable for small and medium-sized enterprises.

 

2.Washing principle

1)The outer surface of bottle uses sprinkler, and the sprinkler pressure can be adjusted by water inflow.

2)The inner surface of the bottle is cleaned by positioning washing, and the rinsing mouth is fixed on the bracket. When the valve body enters the water and the outlet hole comes into contact, the water is pressurized to flush the bottle of the leaking head through the nozzle. The machine adopts city water pressure to flush the bottle. It can also be equipped with low-pressure pump booster cycle to wash bottles according to user needs.

 

3.Operation
1)before use the machine, firstly check whether the various bottle funnels are firmly installed, whether the bucket outlet is properly connected to the lower water pipe, and then connect the water inlet
nozzle,  then make sure the electrical wiring is connected well.
2) turn on the power, start the machine, and at the same time turn on the bottle transfer switch and turn on the water supply switch(or start the water pump)
3)by adjusting the water inflow to get the appropriate washing pressure.
4)Turn off the water switch(or water pump) and cut off the power when stopping the machine.

 

4.Maintenance and repair
1) transmission worm must be add oil once a day,
2)check the strength of each firmware of the flask machine at any time, check whether the motor belt is loose and slippery.

3)When it is found that some sprinkler pressure is not good or no pressure, use the wire to stab the nozzle of sprinkler, if it still can not work well, so need to discharge and clean it.
4)When it is found that the entire machine is not effective, first check whether the water pressure is normal, and then check whether the management pipe is blocked.

 

 

ความเห็น
Copyright MAXXmarketing GmbH
JoomShopping Download & Support